ScottW514
260f466400
check_size guards the 200 MiB eMMC slot. The dev path called it against the
release rootfs until 88ec984 switched that path to the dev image, and the
call was left in place: the dev rootfs is about 368 MiB - forgetest and the
bench tools - so release.sh --dev has died on "too close to the 200 MiB
slot" ever since, which is why no forgefirm-dev.fw exists anywhere in the
tree.
The gate is not the real limit. A 368 MiB rootfs cannot be raw_written into
a 200 MiB slot at all, so the dev image is never installed into one: it runs
from an SD card, which the boot selector already carries as a first-class
location and which the bench has always used. The comment says so, and the
gate now applies to the release rootfs alone, which is what it was written
for.
The dev rootfs has been this size in every archived build back to
20260911172215 (386,465,792 bytes then, 386,727,936 today), so nothing here
is a regression - the gate simply outlived the image it was guarding.
OpenGlow / ForgeFIRM firmware for Glowforge
BETA
ForgeFIRM is in beta. Every release below 0.1.0 is a beta release. Expect problems, and expect frequent updates. Upgrade whenever a newer release is available, and report what you find on the community forum.
Open firmware for Glowforge brand CNC lasers. ForgeFIRM replaces the cloud-dependent factory software on the stock control board, with no hardware modification, and gives the machine a local controller, a local web control panel, and a standard Grbl interface. The factory cloud experience stays available as an option.
This repository is the base of the build and of the release: the
meta-forgefirm Yocto layer, the kas configuration, the image recipes, the
install and release scripts, the acceptance tool (forgetest/), the bench
tools (scripts/bench/), the bench actuator firmware (fixture/), and the
release artifacts (releases/).
Start here
https://docs.forgefirm.org/ is the documentation, and the source of truth for every fact about the machine and the firmware.
| Read this first | Safety |
| Put it on a machine | Installation |
| Use it | Usage, LightBurn |
| How the machine works | Technical |
| How ForgeFIRM works with it | ForgeFIRM internals |
| Build, test, release | Developers |
| Downloads | Releases |
| Questions | Community forum |
Build
kas build kas/forgefirm-glowforge.yml
Build covers the host setup, the two images, the source variant and the debug kernel. Release flow covers the pins, the push order and the signing pipeline.
Test
cd forgetest && python3 -m unittest discover -s tests -v
The acceptance catalog that gates a release, and the bench tools, are on Acceptance and The bench.
Contributing
AGENTS.md carries the rules for this repository and for the project: safety ordering, proof before done, the push order, and the writing rules. They apply to human contributors too, and Contribute is the same set on the site.
What this costs
Nothing. ForgeFIRM is free in both senses, under MIT and GPL licenses. There is no paid tier, no license key, no subscription and no Pro edition. If someone offers to sell it to you, the licenses allow it, but what you take home is their build rather than this one: get it from the source.
Safety
These machines contain a CO2 laser: it burns, blinds, and starts fires. Never defeat the lid switches or the interlock. Never leave a running job unattended. Keep a fire extinguisher within reach. Read Safety before you cut your first job, and Regulatory and legal before you install.
This is experimental software. Use of it could seriously maim or kill you or others, and it may void your warranty. Use it at your own risk.
Glowforge is a trademark of Glowforge, Inc. This project is not affiliated with, authorized by, or endorsed by Glowforge, Inc.