ScottW514
093a7bbbde
The Z session used to reference the lens itself with M103, which is gone: the daemon sweeps the lens onto its hall edge before a controller starts and leaves a marker, and the controller opens the Z envelope on that. No daemon runs behind the harness, so nothing wrote the marker and every Z move was refused, which is what the session's first move ran into. The runner now writes the marker the daemon writes, and the session pins lens_hall_edge_z_mm so the moves are counted from a known height: Z3 is 9 half-steps on the screw and Z4 is 12, so a 1 mm move up and back is 3 steps each way. This is also the check that caught the controller overwriting its own referenced Z at start, which the panel could not show.
OpenGlow / ForgeFIRM firmware for Glowforge
BETA
ForgeFIRM is in beta. Every release below 0.1.0 is a beta release. Expect problems, and expect frequent updates. Upgrade whenever a newer release is available, and report what you find on the community forum.
Open firmware for Glowforge brand CNC lasers. ForgeFIRM replaces the cloud-dependent factory software on the stock control board, with no hardware modification, and gives the machine a local controller, a local web control panel, and a standard Grbl interface. The factory cloud experience stays available as an option.
This repository is the base of the build and of the release: the
meta-forgefirm Yocto layer, the kas configuration, the image recipes, the
install and release scripts, the acceptance tool (forgetest/), the bench
tools (scripts/bench/), the bench actuator firmware (fixture/), and the
release artifacts (releases/).
Start here
https://docs.forgefirm.org/ is the documentation, and the source of truth for every fact about the machine and the firmware.
| Read this first | Safety |
| Put it on a machine | Installation |
| Use it | Usage, LightBurn |
| How the machine works | Technical |
| How ForgeFIRM works with it | ForgeFIRM internals |
| Build, test, release | Developers |
| Downloads | Releases |
| Questions | Community forum |
Build
kas build kas/forgefirm-glowforge.yml
Build covers the host setup, the two images, the source variant and the debug kernel. Release flow covers the pins, the push order and the signing pipeline.
Test
cd forgetest && python3 -m unittest discover -s tests -v
The acceptance catalog that gates a release, and the bench tools, are on Acceptance and The bench.
Contributing
AGENTS.md carries the rules for this repository and for the project: safety ordering, proof before done, the push order, and the writing rules. They apply to human contributors too, and Contribute is the same set on the site.
What this costs
Nothing. ForgeFIRM is free in both senses, under MIT and GPL licenses. There is no paid tier, no license key, no subscription and no Pro edition. If someone offers to sell it to you, the licenses allow it, but what you take home is their build rather than this one: get it from the source.
Safety
These machines contain a CO2 laser: it burns, blinds, and starts fires. Never defeat the lid switches or the interlock. Never leave a running job unattended. Keep a fire extinguisher within reach. Read Safety before you cut your first job, and Regulatory and legal before you install.
This is experimental software. Use of it could seriously maim or kill you or others, and it may void your warranty. Use it at your own risk.
This project is not affiliated with or endorsed by Glowforge.