mirror of
https://github.com/openglow-org/forgefirm.git
synced 2026-09-28 09:11:11 -07:00
ScottW514
8cd98de605
Non-empty gf_serial / gf_password / gf_hostname in /data/forgefirm.conf (set from the forgectrl GF Cloud tab) are applied with set_cfg before Machine() is built, so they beat the OCOTP fuse identity - Machine sets its fuse values with keep_value. The --timeout default comes from GFHOME_TIMEOUT_S when the controller provides it, so one GUI setting governs the whole session. Docs: control-panel runbook notes.
40 lines
1.1 KiB
Plaintext
40 lines
1.1 KiB
Plaintext
# gfhome - Glowforge web-service homing configuration.
|
|
# Copied to /data/etc/gfhome.conf on first run; edit the copy.
|
|
# Machine identity (serial/password) is read from the OCOTP fuses;
|
|
# gf_serial / gf_password / gf_hostname in /data/forgefirm.conf (the
|
|
# forgectrl UI, GF Cloud tab) override it.
|
|
|
|
[SERVICE]
|
|
server_url: https://app.glowforge.com
|
|
status_service_url: wss://status.glowforge.com
|
|
|
|
[FACTORY_FIRMWARE]
|
|
# Homing sessions never fetch factory firmware.
|
|
check: False
|
|
|
|
[LOGGING]
|
|
file: /data/log/gfhome/gfhome.log
|
|
level: INFO
|
|
save_sent_images: False
|
|
|
|
[THERMAL]
|
|
# The heater stays off during homing; thermal policy belongs to the
|
|
# motion controller.
|
|
water_heater_percent: 0
|
|
max_start_temp: 30
|
|
|
|
[MOTION]
|
|
# Extra lens half-steps applied after the hunt (0 = hall reference).
|
|
z_home_offset: 0
|
|
warm_up_delay: 0
|
|
cool_down_delay: 0
|
|
# The factory board's estop sense line reads low during any motion, so
|
|
# it must not gate motion there; enable only on hardware with a real
|
|
# e-stop circuit.
|
|
estop_halts_motion: False
|
|
|
|
[FORGECTRL]
|
|
# Camera captures fetch from the forgectrl daemon (it owns the camera
|
|
# pipeline); direct V4L2 capture is the fallback.
|
|
url: http://127.0.0.1:8080
|