# gfhome - Glowforge web-service homing configuration.
# Copied to /data/etc/gfhome.conf on first run; edit the copy.
# Machine identity (serial/password) is read from the OCOTP fuses;
# gf_serial / gf_password in /data/forgefirm.conf (the forgectrl UI,
# GF Cloud tab) override it. The service hostname always derives from
# whichever serial is in effect.

[SERVICE]
server_url: https://app.glowforge.com
status_service_url: wss://status.glowforge.com

[FACTORY_FIRMWARE]
# Homing sessions never fetch factory firmware.
check: False

[LOGGING]
file: /data/log/gfhome/gfhome.log
level: INFO
save_sent_images: False

[THERMAL]
# The heater stays off during homing; thermal policy belongs to the
# motion controller.
water_heater_percent: 0
max_start_temp: 30

[MOTION]
# Extra lens half-steps applied after the hunt (0 = hall reference).
z_home_offset: 0
warm_up_delay: 0
cool_down_delay: 0
# The factory board's estop sense line reads low during any motion, so
# it must not gate motion there; enable only on hardware with a real
# e-stop circuit.
estop_halts_motion: False

[FORGECTRL]
# Camera captures fetch from the forgectrl daemon (it owns the camera
# pipeline); direct V4L2 capture is the fallback.
url: http://127.0.0.1:8080