The gf_hostname override is gone (the forgectrl UI no longer offers
it): the hostname is a pure derivation of the serial - base 23 over
the factory consonant alphabet - so a gf_serial override re-derives
MACHINE.HOSTNAME and the fuse derivation stands otherwise. BRINGUP
records the panel rework (units, fuse identity, always-on position)
as offline-verified; board deploy and pin bumps held during the
firmware-upgrade bench testing.
Non-empty gf_serial / gf_password / gf_hostname in /data/forgefirm.conf
(set from the forgectrl GF Cloud tab) are applied with set_cfg before
Machine() is built, so they beat the OCOTP fuse identity - Machine sets
its fuse values with keep_value. The --timeout default comes from
GFHOME_TIMEOUT_S when the controller provides it, so one GUI setting
governs the whole session. Docs: control-panel runbook notes.
The runner's Machine subclass fetches lid/head images from the
forgectrl snapshot endpoint - forgectrl owns the imx-media pipeline
whenever a stream client (LightBurn) is connected, so direct V4L2
grabs fail busy. Head captures request lamp=0 (the cloud's focus
analysis needs torch-off images); the HCil measure-laser LED is still
driven directly. Direct capture remains the fallback when the daemon
is unreachable.
The sample config gains the factory-board settings: the estop motion
gate stays off (the board's estop sense reads low during any motion),
and the forgectrl URL is configurable.
New recipe installing /usr/sbin/gfhome.py and /etc/gfhome.conf.sample
(copied to /data/etc/gfhome.conf on first run). The runner signs the
machine in with its fused identity, opens the WSS control channel with
a held client reference (a clean disconnect is impossible through
ws_connect), and drives the GFUIService dispatch table itself - minus
print - so the service's camera homing sequence (settings -> hunt ->
lid image -> corner move -> lid image) runs against the real hardware
Machine. The service ends the sequence silently, so completion is a
hunt plus at least one motion followed by a configurable quiet window;
the lens is then re-referenced against the hall sensor for a
deterministic Z. Lid/e-stop are checked before the session, print
actions are refused, and exit codes distinguish configuration and
connection failures from an incomplete homing.
Installed in both images; invoked by the grblHAL controller for $H
when homing_mode = gfcloud in /data/forgefirm.conf.
ScottW514